So I’m not sure whether that one helps you out at all, but it’s not considered a “button” the way the ones are in the previous link that I gave you, so I did just want to mention it in case it helps in this specific situation. Offering stunning 26MP image resolution, good. Or of course, you could use the linear/gocontrol control switch with its own master switch. Best smart light switch for HomeKit: Lutron Caseta In-Wall Smart Dimmer Switch. That means the Linear/go control switch doesn’t have to be on the same circuit. So again, depending on your wiring, you could use a GE master switch and a linear/go control add on switch, with the add on switch talking directly to the smartthings hub rather than to the master. Use the smart switch to set your front porch lights to turn on at dusk. It doesn’t use traveler wires to communicate with its own master switch it always uses a virtual three-way. Includes: (2) Caseta smart switches, (1) smart bridge, (1) wireless Pico remote.
Just read the descriptions carefully to make sure it will fit you use case.īTW, if your wiring would allow for a GE add on switch, it should also allow for the Linear/GoControl add on switch, and that one does have its own zwave radio and can communicate directly with the smartthings hub. The following FAQ lists both battery powered and mains powered devices, both wall mount and table top, so you might find something there that works for you. And there are a number of other battery operated devices which could be used.
The device talks to the hub, the hub talks to the master switch. That said, as he also mentioned, any device which can communicate directly to the smartthings hub can be used in a virtual three-way. So they cannot be used with any other brand. In fact, the Lutron pico switches are invisible to SmartThings in the official integration the only thing they can be used for is to control a Lutron master switch.Īnd as it happens, the GE add on switches are also themselves invisible to the smartthings hub – – they don’t have any radio at all, and just communicate with their master switch with pulses over the traveler wire.
As said, your initial idea won’t work, they’re just not compatible.
0 kommentar(er)
